Starting / Stopping The Engine - Stihl TS 400 Instruction Manual

English
Starting / Stopping the
Engine
3
2
3
Note the safety instructions. Refer
N
to the chapter headed "Safety
precautions and working
techniques".
Press throttle trigger interlock (1)
N
and throttle trigger (2)
simultaneously
Hold both triggers down
N
Move the Master Control lever (3) to
N
START and hold it in position too
Release the throttle trigger, slide
N
control and throttle trigger interlock
in succession = starting throttle
position
22
Choke
1
Set choke lever (4) depending on
N
engine temperature
g If engine is cold
e if the engine is warm (even if the
engine has already run but is still
cold
f if the engine is hot (lock-in position
for hot start)
Press the button of the
N
decompression valve (5) - this
button must be pressed again
before each fresh attempt to start
the engine.
4
5
Starting
Place the cut-off machine carefully
N
on the ground, ensuring that the
abrasive wheel cannot touch the
ground or any objects. There must
not be anyone within the swivel
range of the cut-off machine
Make sure you have a firm footing
N
Press the cut-off machine firmly
N
against the ground, holding the
handle with your left hand, thumb
wrapped round the handle
Place your right foot on the shroud
N
TS 400