Cutting Wheels - Stihl TS 400 Instruction Manual

English
Shaping pipe
Mark a cutting line
N
Manual cutting along this line requires
particular caution and precision.
Grind a guide groove along the
N
marked cutting line – do this by
starting at the apex and cut outward
on both sides
Cut into pipes, round bodies, etc. in
N
the area at the ends of the cutting
line, so that the material does not
break away
Make cuts deeper with even back
N
and forth motions – start at the apex
and cut outwards on both sides –
feed with full cutting depth along the
guide groove – for small corrections
of direction, do not tilt the cutting
wheel, but always position it anew
instead – if necessary, leave small
12
ridges that hold the part that is to be
separated in position. Break these
ridges later

Cutting wheels

Cutting wheels are exposed to
extremely high loads especially during
freehand cutting.
The cutting wheels, which have been
developed by STIHL in cooperation with
renowned manufacturers of abrasive
wheels, are of high quality and tailored
precisely to the respective intended use
as well as the engine performance of the
cut-off machine.
They are of consistently outstanding
quality.
Transport and storage
Do not expose cutting wheels to
–
direct sunshine or other thermal
stresses during transport and
storage
Avoid jolting and impacts
–
Stack cutting wheels flat on a level
–
surface in the original packaging in
a dry place where the temperature
is as constant as possible
Do not store cutting wheels in the
–
vicinity of aggressive fluids
Store cutting wheels in a frost-free
–
place
TS 400