Fitting / Replacing An Abrasive Wheel - Stihl TS 400 Instruction Manual

Fitting / replacing an abrasive
wheel
The engine must be switched off for
fitting or replacement – set slide control /
master control lever / stop switch to
STOP or 0.
Blocking the shaft
1
Slide the locking pin (1) through the
N
bore in the V-belt guard
Turn the shaft with the combination
N
wrench until the locking pin (1)
engages in a bore behind the guard
TS 400
Removing an abrasive wheel
Use the combination wrench (2) to
N
loosen and remove the hexagon
head screw
Remove the front thrust washer (3)
N
(flange) from the shaft together with
the abrasive wheel
Fitting a new abrasive wheel
Fit the new abrasive wheel (4)
N
Note the arrows indicating the direction
of rotation on diamond abrasive wheels.
Fit the front thrust washer (3)
N
(flange). The catches of the front
thrust washer (3) (flange) must
engage in the shaft grooves.
Screw in the hexagon bolt and
N
tighten it with the combination
wrench – if using a torque wrench,
refer to the "Technical Data" for the
tightening torque
Draw the locking pin out of the
N
V-belt guard
English
19