Stihl TS 400 Instruction Manual page 19

Inboard mounting
2
The arrow on the tensioning nut (2) must
point to 0 .
otherwise, turn the tensioning
N
nut (2) counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
TS 400
5
4
6
7
8
Fit the V-belt (3) over the V-belt
N
pulley (4)
Line up the threaded holes in the
N
bearing plate (5) with the oblong
holes in the cast arm (6)
Push the V-belt guard (7) into place
N
Screw in the hexagon head
N
screws (8) as far as possible – do
not tighten them down yet
Continue as described in the chapter
"Tensioning the V-belt".
Outboard mounting
3
The arrow on the tensioning nut (2) must
point to 0 .
otherwise turn the tensioning nut (2)
N
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
English
2
17