Stihl TS 400 Instruction Manual page 32

English
6
Lever the rope out of the starter
N
handle with a screwdriver
Remove the remainder of the rope
N
from the rotor and starter handle
Thread a new ElastoStart starter
N
rope from top to bottom through the
handle and rope guide bush (6)
30
Thread the rope through the rotor
N
and secure it in the rotor with a
simple overhand knot
3
4
5
Slip the rope rotor onto the starter
N
post – turn it back and forth a little
until the anchor loop of the rewind
spring engages
Refit the pawl (5) in the rope rotor
N
Place the washer (4) on the starter
N
post
Press the spring clip (3) on to the
N
starter post and over the pegs of the
pawl with a screwdriver or suitable
pliers – the spring clip must point in
the clockwise direction – as in the
picture
TS 400