Idnet Diagnostics; Procedure; Duplicate Devices; Weak Answer Devices - Simplex 4010 Service Manual

IDNet Diagnostics

Procedure

Duplicate Devices

Weak Answer Devices

Technical Manuals Online! - http://www.tech-man.com
1. Press <MENU>.
2. Press <NEXT> or <PREVIOUS> until [Diagnostics] is displayed and
then press <ENTER>.
3. Press <NEXT> or <PREVIOUS> to select [IDNET DIAGNOSTICS] and
then press <ENTER>.
4. Press <NEXT> or <PREVIOUS> to select either [DUPLICATE
DEVICES] or [WEAK ANSWER DEVICES] and press [Enter].
To detect devices set to the same address you can activate the IDNet Diagnostics
- Duplicate Device option. Once activated, there is a trouble in the panel
indicating that you have activated the option. The two devices set to the same
address then come in as a duplicate device trouble for that address.
Acknowledge the trouble and view the point information to determine the
address that the devices are set to and correct the problem.
Duplicate devices are also detected during a Quick CFIG. If a duplicate device
is detected during a Quick CFIG, the Quick CFIG terminates and the following
occurs:
•
If the duplicate address is a smoke detector, the panel turns ON the LEDs of
the devices.
•
If the device is not a detector with an LED, program the device types and
point types of all points, download the job to the panel, and use the NO
Answer Trouble messages to determine which devices have duplicate
addresses.
When receiving a Weak Answer Trouble you can determine which device is
causing the trouble by activating the IDNet Diagnostics - Weak Answer option.
When activated there is a trouble in the panel informing you that the option is
active. Acknowledge the trouble and wait. Any device that is weak will then
report NO ANSWER when the Weak Answer Diagnostic is run.
C-3