Removal and replacement procedures
Installing the HP Docking Station Lock on the HP Docking Station
✎
A security cable is designed to act as a deterrent, but it may not prevent the computer or the docking station from
being mishandled or stolen.
The HP Docking Station Lock (purchased separately) allows you to secure the docking station and a docked
computer. Loop the cable around a stationary object, connect the security cable to the security cable port on the rear
of the docking station, and then install the lock into the lock slot on the right side of the docking station, as shown
in the following procedure.
Lock position
0
1
2
4–6
Voltage protection level
Use this position to install or remove the lock and security cable. In this
position, all equipment is unsecured:
■ The key cannot be removed from the lock.
■ The lock can be installed or removed.
■ The security cable can be installed or removed.
■ The computer can be docked or undocked.
Use this position to secure equipment, as follows:
■ The key can be removed from or inserted into the lock.
■ The lock is secured.
■ The security cable is secured.
■ The docking station is secured.
■ The computer can be docked or undocked and is unsecured.
In this position, all equipment is secured, as follows:
■ The key can be removed from or inserted into the lock.
■ The lock is secured.
■ The security cable is secured.
■ The docking station is secured.
■ The docked computer is secured.
Maintenance and Service Guide