Component replacement procedures
If there is a concern with the docking station which requires a replacement of hardware, a whole new unit must be
requested.
Serial number
Report the docking station serial number to HP when requesting information or ordering a new unit. The serial
number is located on the bottom of the docking station. See "Service tag location".
Removing the computer from the HP Docking Station
Perform the following steps to remove the computer from the docking station:
1. Close the computer. If you close the computer when the power is on, the computer may enter the Sleep state or
Standby. To resume operation after undocking, open the computer, and then press the power button.
2. Press the eject button 1. The computer disconnects from the docking station.
Lift the computer away from the docking station 2.
Maintenance and Service Guide
Removal and replacement procedures
4–5