Subscribe to Our Youtube Channel
Related Manuals for Lionel Hudson Jr.
Summary of Contents for Lionel Hudson Jr.
- Page 1 72-1951-250 LIONEL 3/00 Hudson Jr. Steam Locomotive Owner’s Manual SignalSounds/Conventional RailSounds...
-
Page 2: Table Of Contents
• Lionel electronic reversing unit Table of Contents Transformer operations Running your locomotive with a Lionel transformer Installing the Lionel no. 610-5906-001 sound activation button Your locomotive’s 103-1 reverse unit operation Using your locomotive’s magnetic coupler Experiencing the range of your locomotive’s Signalsounds Tire-Traction™... -
Page 3: Transformer Operations
Move ‘em out! • Get your locomotive moving. Press the DIR button on your CAB-1 remote or Lionel transformer. This sequences the Lionel 103-1 reverse unit to the next oper- ating state. The 103-1 unit alternates between three states: forward, neutral, and reverse. -
Page 4: Installing The Lionel Sound Activation Button
For AC transformers lacking a horn/whistle button The no. 610-5906-001 button works with any Lionel AC transformer except no. Note! 6-4690 Type MW. Transformers made by other manufacturers may not be compatible with Signalsounds. -
Page 5: Your Locomotive's 103-1 Reverse Unit Operation
Transformer operations Your locomotive’s 103-1 Reverse unit he reverse unit inside your Lionel loco- have no affect on the direction of the loco- motive is an electronic device that acts motive. like the transmission in your car. When you Additionally, this reverse unit has a apply power to the track, the locomotive “power-up reset”... -
Page 6: Using Your Locomotive's Magnetic Coupler
Transformer operations Using your locomotive’s magnetic coupler he rear of your Lionel locomotive’s ten- magnetic field pulls the disc downward, and der is equipped with an operating mag- the knuckle opens. netic knuckle cou- One operating pler, a revolutionary technique favored by... -
Page 7: Operating Your Signalsounds™/Conventional Railsounds™ Locomotive
Operating your SignalSounds™/ Conventional RailSounds™ Experiencing the SignalSounds/Conventional Railsounds system ith SignalSounds and Conventional RailSounds. Turn off track power, and RailSounds, you experience the sounds after the air-release reset sound, you have of real railroading like never before. Simply two seconds to restart your Locomotive. If put, it’s the most sophisticated, authentic you’re done with operations, RailSounds model railroad sound system in the world. -
Page 8: Enhanced Towercom
Operating your Conventional RailSounds™ Example Enhanced TowerCom™ • User brings the engine to a stop and sounds a nhanced “TowerCom” is a two part mes- short horn blast. sage involving a “stand-by” or “clear for • TowerCom message says, “Please stand by” departure”... -
Page 9: Adding Fluid To Your Locomotives Smoke Generator
(see page 11 The smoke generator requires the periodic for location). Move the switch to off and your addition of Lionel smoke fluid in order to locomotive will stop smoking. function. Pierce the tube end with a pin, then... -
Page 10: Lionel Service
Lionel Service Center or Lionel Service. See minated by one lamp. During the course the Lionel Service section on page 12 for of normal operation, the lamp may require more information. Remove the expired lamp replacement. -
Page 11: Lubricating Your Steam Locomotive
Maintaining your locomotive Lubricating your steam locomotive elp your Lionel steam locomotive lead a dust before lubricating, and always lubricate long and productive life on your rail- any locomotive emerging from prolonged road by maintaining it properly. storage. Also, lightly lubricate the steam We recommend you purchase a Lionel locomotive’s side rods after each 10 hours of... - Page 12 Website @ www.Lionel.com consumer-purchaser, for one year against original If you prefer to send it back to Lionel L.L.C. for defects in materials or workmanship when pur- factory repair, you must first call 810-949-4100 or chased through an authorized Lionel merchant.
Need help?
Do you have a question about the Hudson Jr. and is the answer not in the manual?
Questions and answers