Running Your Locomotive In The Trainmaster Command Environment; Cab-1 Remote Controller Commands For Your Locomotive - Lionel RS-11 Owner's Manual

TrainMaster Command operations
Running your locomotive in the TrainMaster Command Control
environment
Example
Address Locomotive #1
Set PowerMaster to CMD or traditional
power supplies to full throttle (no more
than 19 volts)
Press ENG
Press 1 (the ID#)
Throttle up/press any command button

CAB-1 Remote Controller commands for your locomotive

RailSounds sound system effects in bold italic.
Front coupler releases.
Coupler release
sounds.
Rear coupler releases.
Coupler release
sounds.
Activates the
numeric keypad.
Air-release
sound.
Press AUX2 to turn
your locomotive's
headlights on and
off.
Turn the THROTTLE
to the right to
accelerate, left to
decelerate.
Press HALT to shut
down all PowerMaster
electrical output on
your railroad. Stops all
Command-equipped
Lionel locomotives in
operation.
Note!
Use
HALT
only in emergency situations.
Y our Command-equipped locomotive
comes factory-programmed with an
ID# of "1." To address your locomotive,
set PowerMasters to CMD or set all power
supplies on full (no more than 19 volts).
Press ENG and 1 on your CAB-1 Remote
Controller. Turn the throttle or press any
command button; your locomotive is
ready for Command Control operations.
discontinue. MultiHorn diesel
horn sound.
mechanical bell sound.
throttle up, and the locomotive will
accelerate in the opposite direction.
There is no neutral state. Diesel
air-release sound.
locomotive's previous speed.
return to the previous speed.
Squealing brake sounds.
11
Press WSTL/HRN to
activate the locomotive's
horn, release it to
Press BELL once to acti-
vate the bell, again to
discontinue. Diesel
Press DIRECTION—the
locomotive decelerates to a
complete stop; turn the
Press and hold BOOST
for extra power. Release
BOOST and return to the
Press and hold BRAKE
to slow down or stop.
Release BRAKE and
Beneath this panel
SET L M H