Panasonic WV-CS854A Operating Instructions Manual page 17

3. Pan Offset
If the camera is replaced with a new one, Pan Offset is used to
adjust its positions to be the same as before except patrol setting.
The controller can be downloaded or uploaded the camera preset
position data.
Caution: The preset data for conventional camera (WV-CS654 for
example) is incompatible with WV-CS854A's. WV-CS854A's
preset data will be destroyed if you upload the conventional
data. When this happened, prepare a WV-CS854A having the
initial factory settings. Download the factory settings into the
controller and then upload to the camera whose data is
destroyed.
(1) Display the PRESET NUMBER SET menu.
(2) Select a position number for the picture to be most enlarged
among the numbers by moving the joystick. Then press the
CAM (SET) key. POSITION setting menu appears.
(3) Move the cursor to PAN OFFSET SET and select the right or
left arrow by moving the joystick.
(4) Press the CAM (SET) key until the desired offset value in
degree appears.
(5) Move the cursor to other than PAN OFFSET, then press the
MON (ESC) key.
Notes:
• Further adjustment of the other positions is unnecessary. This
adjustment applies to all other positions.
• Make sure to move the cursor before pressing the key in step
5. Otherwise the settings will be ignored.
• Retry when the camera fails to upload or download the data.
4. To Set the Lens Zoom and Focus Positions
(1) Move the cursor to PUSH SET next to ZOOM/FOCUS and
press the CAM (SET) key. The ZOOM/FOCUS setting menu
appears.
(2) Select a zoom position by moving the zoom control up and
down, and a focus position by moving the focus control up
and down, and then press the CAM (SET) key.
The positions are set and the screen returns to the position
setting menu.
Notes:
• When the camera is used at a nearly horizontal angle, the
focus may not be adjustable to a high level of accuracy.
• If you move the cursor to POSITION number and move the
joystick right or left, the position number can be selected.
The selected preset position number can also be set after
pressing the CAM (SET) key.
• The preset and camera IDs appear at the lower-left corner of
the position setting menu after setting them.
5. Move the cursor to RET and press the CAM (SET) key to return to
the preset setting menu.
18
PRESET NUMBER SET menu
(1-32)
** PRESET NUMBER SET **
1* 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
17 18 19 20
21 22 23 24
25 26 27 28
29 30 31 32
ID:DOOR
33-64 RET
Position setting menu
** POSITION 1 **
PAN/TILT PUSH SET
ZOOM/FOCUS PUSH SET
PAN OFFSET SET 0.0
RET
FLOOR1
DOOR
Position setting menu
** POSITION 1 **
PAN/TILT PUSH SET
ZOOM/FOCUS PUSH SET
PAN OFFSET SET 0.0
RET
FLOOR1
DOOR
ZOOM/FOCUS setting menu
** POSITION 1 **
PAN/TILT PUSH SET
ZOOM/FOCUS PUSH SET
U ZOOM D/L FOCUS R
PAN OFFSET SET 0.0
RET
FLOOR1
DOOR
Position setting menu
** POSITION 1 **
PAN/TILT PUSH SET
ZOOM/FOCUS PUSH SET
PAN OFFSET SET 0.0
RET
FLOOR1
DOOR