Panasonic WV-CS854 Installing
Camera with a dvx system
Hide thumbs
Also See for WV-CS854:
- Operating instructions manual (120 pages) ,
- Operating instructions manual (57 pages) ,
- Operating instructions manual (56 pages)
Related Manuals for Panasonic WV-CS854
Summary of Contents for Panasonic WV-CS854
- Page 1 Installing PTZ Cameras on a DVX system Panasonic WV-CS854 Dome External RS-485 Control June 2002 #3000-40046 Rev. 2...
- Page 2 Installing Panasonic WV-CS854 on a DVX system To use a Panasonic WV-CS854 camera with a DVX system , you must wire the camera to the RS-485 converter, and then plug the converter into the COM port on the DVX system. The A pin must be connected to the orange T and yellow R wires...
- Page 3 Panasonic WV-CS854: Setup Instructions The figure on the previous page shows the SW1 switch used to select the protocol, communication parameter, and camera address. You must set this switch three times, as described in the following instructions: Select the protocol by setting SW1 as follows (factory default settings): Insert the camera in its mount and wait for the camera to complete the startup sequence.
- Page 4 Set SW2 as follows if the camera is not the final camera in a chain: Set SW2 as follows if the camera is the final camera in a chain: See the Panasonic WV-CS854 installation manual for more information. Panasonic WV-CS854: Connecting Multiple Cameras Additional cameras are connected to the DVX system in a daisy chain, star, or combination configuration;...
- Page 5 Enabling COM Ports (Upgrade Situtations Only) When upgrading an existing DVX system to enable PTZ capability, you must enable the COM ports on the DVX system. To verify that the COM ports are enabled on your system, view the PTZ tab on the Setup page in MasterControl on the DVX system.