iCharger 4010DUO User Manual page 22

iCharger iCharger Synchronous Synchronous
iCharger iCharger Synchronous Synchronous Balance
⑤Power
Power Power Power Supply Supply Supply Set Supply Setup Set Set up up up
Select SYSTEM MENU→Charger Setup→Power Supply to enter the setup interface.
After selecting input source, click the "
set the parameters, after setting click "
⑥Save
Save & & & & Load Save Load Configuration
Save Load Configuration Load Configuration Configuration Set
Select Save Save Save Save & & & & Load Load Load Config Config on SYSTEM MENU and enter the setup interface. Config
Load Config
Note: 1. Users can save configuration to SD card, just load via SD card if use again.
2. After loading the configuration files, in addition to Calibration Select , it will cover all
settings within the device.
Balance Balance Charger/Discharger Charger/Discharger
Balance Charger/Discharger Charger/Discharger
" followed the option, enters the relevant power supply setting to
"to save and return to the previous interface.
Set up
Setup Set up up
- 22 -
DC Power Supply Setting
Low Voltage Limit: 9V-48V; default: 10V
1A-65A; default: 65A
Current Limit:
Battery Power Source Setting
Low Voltage Limit: 9V-48V; default: 10V
Current Limit: 1A-65A; default: 65A
1: Regenerative Enable
2. Regen. Voltage Limit:
3. Regen. Current Limit:
Tick Regenerative enable to active power supply
regenerative feature, enable the charger to charge
back to the power supply in the discharge process.
4010DUO 4010DUO
4010DUO 4010DUO
9V-48V; default: 14.5V
1A-65A; default: 10A