Table of Contents
Advertisement
Section 4: SCSI Bridge Electronics
2.6
Setup 1 Configuration Display Format Items
Enter
Set-Up 1
PRESS to
Select
Tape
Term: On
*NOT sel
ectable*
Figure 54
2.6.1
Setting the host SCSI ID
SCSI ID:
[00]
PRESS to
Alter
Figure 55
This configuration menu item sets the host SCSI ID used by the NonStop server to select the tape
drive. Enter a value (0 to 15) using the Numeric Entry Method. No two devices can have the same
SCSI ID on the host bus. For available SCSI Ids consult your system administrator.
Note:
The ability to independently set the tape drive SCSI ID and the NonStop server SCSI ID is very
useful. The tape drive ID can be altered from tape drive front panel without regard to the actual
physical SCSI ID of the drive itself, making SCSI device additions quick and simple.
2.6.2
Setting the Tape Drive SCSI ID
Tape ID:
[00]
*NOT sel
ectable*
Figure 56
HP StorageWorks DAT 72 (Models 5242 and 5242-ACL) User's Guide
SCSI ID:
Tape ID:
[00]
PRESS to
*NOT sel
ectable*
Alter
Density:
Rwr% 0.5
[C0]
Ecc: 0.5
PRESS to
PRESS to
Alter
Alter
Exit
Set-Up 1
PRESS to
Select
Setup 1 configuration items
SCSI ID:
[01]
PRESS to
Incremnt
Setting the host SCSI ID
Setting the tape drive ID
[00]
SCSI ID:
[01]
PRESS if
Done
56
HP Part Number 528296-03 July 2005
Advertisement
Table of Contents
