HP dat72 5242 User Manual page 51

Section 3: HP 5242-ACL Tape Drive
Locate Status
Mag Check Status
Mag Eject Status
Mag Loaded Status
New FW!!!! Status
No Error Flashing The drive is trying to read
EODmark
Partition Status
Partition 1 Error
too large
Read Status
Read Fail Error Flashing A read has failed. The host
Rewind Status
SCSI Error Error
SCSI ID: x Info
HP StorageWorks DAT 72 (Models 5242 and 5242-ACL) User's Guide
The drive is moving the
tape to a point specified by
the host.
The autoloader is
examining the magazine to
discover occupied slots.
The autoloader is ejecting
the magazine.
A magazine is loaded and
the magazine check has
been carried out.
The firmware upgrade
process has been
successfully completed.
what appears to be a blank
tape (one with no DDS-
format EOD pattern).
Probably a result of a
power-fail while writing.
The drive is switching to
the other partition on a
two-partition tape.
On A command to format the
tape has failed because the
request size for partition 1
is too large.
The drive is reading data
from the tape.
should reposition and try
again.
The drive is rewinding the
tape to the beginning of
partition.
On A SCSI command error has
been detected.
x indicates the SCSI ID of
the autoloader. During the
power-on sequence, it
displays for 2 seconds
following the product
identifier.
Try again with a
smaller partition 1 or,
if possible, a longer
tape.
Check the SCSI
interface connection
and try again.
44 HP Part Number 528296-03 July 2005