Turning Off The Power - Panasonic PT-L735E Operating Instructions Manual

& Press the input select button to select the
input signal.
Input select
VIDEO
buttons
VIDEO
Changing
signals
S-VIDEO
BA picture will be projected in accordance with the selected input signal.
Follow the procedure below when you set the projector up first, and when
you change the setup place.
Adjusting the angle
'
BWhile pressing the adjuster buttons,
adjust the forward/back angle of tilt
of the projector. Adjust so that the
projector is as vertical to the screen
as possible.
Press the AUTO SETUP button to initiate
(
automatic positioning.
BThe tilt of the projector and the input
signal will be detected and keystone
distortion and the position of the
image will be corrected.
(Refer to page 27 for details.)
Adjusting the size
)
BTurn the zoom ring to adjust the size of the projected image.
Adjusting the focus
*
BTurn the focus ring to adjust the focus of the projected image.
24-E
NGLISH
PT-L735NTE
RGB RGB
only
RGB1 RGB1 RGB2
RGB2 SDCARD NETWORK

Turning off the power

#
POWER AUTO SETUP
RGB LASER
VIDEO MENU
PAGE
$
R-CLICK
ENTER
# Press the POWER button.
B"Power OFF" is displayed on the
screen.
$ Select "OK" using the I I and H H buttons and
then press the ENTER button.
BThe lamp unit will switch off and the picture will stop being projected.
(The power indicator on the projector will illuminate orange.)
% Press the MAIN POWER switch to turn off the
power after the power indicator on the
projector illuminates red.
Direct power off function
You can turn off the MAIN POWER switch and move the projector immediately after use.
The cooling fan will operate by the internal power supply to cool down the lamp.
B When this function is used, it may take more time for the lamp to turn back on again
compared to when the lamp cools down while the MAIN POWER switch is ON.
B Do not put the projector in a bag while the cooling fan is operating.
%
Power indicator
RGB input indicator
E -25
NGLISH