Noise Reduction (Nr), White; Projecting Srgb-Compatible Pictures; Colour Hue Setting; Color Temp - Panasonic PT-L735E Operating Instructions Manual

CONTRAST
This adjusts the contrast of the
picture. Press the H button to make
the picture brighter, and press the
I button to make the picture
darker. (Adjust the BRIGHT setting
first if required before adjusting the
CONTRAST setting.)
BRIGHT
This adjusts the darker areas (black
areas) in the picture. Press the H
button if dark areas are too solid (for
example, if hair is difficult to see), and
press the I button if black areas are
too light (grey rather than black).
COLOR
(S-VIDEO/VIDEO/YP P only)
B R
Press the H button to make the
colour more vivid in tone, and press
the I button to make the colour
more pastel in tone.
TINT
(NTSC/NTSC 4.43/YP P only)
B R
This adjusts the flesh tones in the
picture. Press the H button to make
flesh tones more greenish, and
press the I button to make the
flesh tones more reddish.
SHARPNESS
Press the H button to make the picture
details sharper, and press the I button
to make the picture details softer.

Colour Hue Setting

(COLOR TEMP.)

This is used to adjust the white
areas of the picture if they appear
bluish or reddish.
38-E
NGLISH
Noise Reduction (NR)
(When S-VIDEO/VIDEO/YP P
B R
signals are being input)
If the signal is of such poor quality
that picture interference appears, you
can suppress this interference by
adjusting the NR (Noise Reduction).
To strengthen the effect, press the H
button. To turn it off , set to "0" by
pressing the I button.
WHITE BALANCE R/G/B
(RGB only)
This is used to adjust the white
areas of the picture if they appear
colourised. Press the I button to
make the selected colour lighter.
Press the H button to make the
selected colour stronger.
TV-SYSTEM
(S-VIDEO/VIDEO only)
AUTO1
The projector automatically
distinguishes between NTSC/NTSC
4.43/PAL/PAL60/SECAM signals.
AUTO2
The projector automatically
distinguishes between NTSC/PAL-
M/PAL-N signals.
NOTE:
B This should normally be set to
"AUTO1" or "AUTO2". If the
signal is of such poor quality
that the correct format cannot
be automatically distinguished,
change the setting manually to
the required TV system.
Projecting sRGB-
compatible pictures
sRGB is an international colour
reproduction standard (IEC61966-2-
1) established by the International
Electrotechnical Commission (IEC).
If you would like the colours in
sRGB-compatible pictures to be
reproduced more faithfully, make
the following settings.
# # Press the F F or G G button to
select "PICTURE MODE", and
then use the I I or H H button to
select "NATURAL".
$ $ Press the F F or G G button to
select "COLOR TEMP.", and
then use the I I or H H button to
select "STANDARD".
% % Press the STD (standard)
button on the remote control
unit.
& & Select the LAMP POWER item
in the OPTION menu by
pressing the F F or G G buttons
and set to "HIGH" by pressing
the I I or H H buttons.
NOTE:
B sRGB is only enabled when
RGB signals are being input .
E -39
NGLISH