Adjusting The Position - Panasonic PT-L735E Operating Instructions Manual

Adjusting the position

When the input signal is RGB, first
press the AUTO SETUP button to
initiate automatic positioning.
If the optimum setting is not obtained
when AUTO SETUP is carried out,
adjust by the following procedure.
Select the item pressing the F or G
buttons on the remote control unit or
the projector.
Press the I or H buttons, to adjust
the alternative items. For the
numerically adjustable items, press
the ENTER button to display an
individual screen, and press the I
or H buttons to adjust the setting.
Some items can be adjusted
pressing the F or G buttons.
When an RGB signal is being input
When a YP P signal is being input.
B R
40-E
NGLISH
When an S-VIDEO/VIDEO signal is
being input
When the NETWORK/SD CARD is
selected
POSITION
Moves the picture position.
Press the I or H buttons to move the
picture horizontally.
Press the F or G buttons to move the
picture vertically.
DOT CLOCK
(RGB only)
Periodic striped pattern interference
(noise) may occur when a striped
pattern such as the one below is
projected. If this happens, use the
I and H buttons to adjust so that
any such noise is minimised.
CLOCK PHASE
(RGB only)
Adjust the DOT CLOCK setting first
before carrying out this adjustment.
Use the I and H buttons to adjust so
that the noise level is least noticeable.
NOTE:
B If signals with a dot clock
frequency of 100 MHz or higher
are being input, interference may
not be completely eliminated when
the DOT CLOCK and CLOCK
PHASE adjustments are carried
out.
KEYSTONE
Before carrying out keystone
correction, 1) adjust the forward/back
angle of tilt of the projector by pressing
the adjuster buttons and 2) press the
AUTO SETUP buttons to correct
vertical keystone distortion. (page 27)
The vertical keystone distortion will be
automatically corrected by the
projectors automatic setup function.
However the horizontal distortion needs
to be corrected or a tilted screen needs
to be adjusted manually by following
any of the procedures in the table.
Picture
Operation
condition
Press the F F
button.
Press the G G
button.
Press the I I
button.
Press the H H
button.
NOTE:
B If you press the AUTO SETUP button
after correcting the keystone distortion
manually, the automatic keystone
correction function will operate and the
corrected picture will return to its
previous incorrect condition. In addition,
if you change the input signal and press
the AUTO SETUP button, the keystone
correction may be cancelled depending
on the type of signal and the angle of tilt
of the projector. To prevent them from
happening, you can set "AUTO
KEYSTONE" in the OPTION menu to
"OFF"
B The greater the correction of keystone
distortion amount, the more the picture
quality will deteriorate, and the harder it
will become to achieve a good level of
focus. To obtain the best picture quality,
set up the projector and screen in such
a way that the amount of keystone
correction required is as minimal as
E -41
NGLISH