Bosch AFS 23-37 Original Instructions Manual page 18

OBJ_BUCH-2432-003.book Page 18 Monday, December 7, 2015 9:50 AM
18 | English
Problem Possible Cause
Machine functions Extension cable damaged
intermittently
Internal wiring of machine damaged
Machine does not cut Cutting blade/line damaged
Increased vibration Cutting blade damaged
Cutting line broken
Debris build up on cutting head
Blade nut loose
Machine leaves ragged fin- Grass too high/dense
ish and/or labours
Cutting blade blunt
Cutting blade obstructed
Debris build up on cutting head
Nut cannot be removed to Damaged thread on nut/shaft
release cutting blade
Locking pin not located correctly
Cutting blade fails to Cutting blade obstructed
rotate
Blade nut loose
Grass too high/dense
Poor cutting performance Cutting guard encrusted with debris
Cutting blade blunt
No cutting line
Poor motor performance
If you are unable to resolve the problem using the Troubleshooting guide then please contact your dealer in the first instance.
F 016 L81 230 | (7.12.15)
Corrective Action
Inspect cable, replace if damaged
Contact Service Agent
Contact Service Agent
Replace the blade/line (always wear protective
gloves)
Replace the blade (always wear protective
gloves)
Replace line
Clean slip plate groove
Tighten nut bolt to 20 Nm ensuring the blade,
nut shield and dome washer are all present and
central (always wear protective gloves)
Grass too high: Cut in stages
Grass too dense: Reduce rate of cutting every
time
Flip/replace blade
Check underneath the machine and clear out as
necessary (always wear protective gloves)
Clean slip plate groove
Lubricate shaft to aid removal
Reinsert locking pin and apply light pressure
whilst rotating shaft
Check underneath the machine and clear out as
necessary (always wear protective gloves)
Tighten nut ensuring the blade, rider plate and
dome washer are all present and central
(always wear protective gloves) (see figure 3)
Grass too high: Cut in stages
Grass too dense: Reduce rate of cutting every
time
Clean inside of cutting guard
Flip/replace blade
Replenish line
Remove cutting system and slip plate and clean
slip plate groove
Bosch Power Tools