Yamaha FZ8NA Service Manual page 99

1. Cable guide
2. Fuel tank drain hose
3. Fuel tank breather hose
4. Brake fluid reservoir hose
5. Rear wheel sensor lead
6. AC magneto lead
7. Rectifier/regulator lead
8. Rear brake light switch lead
9. Frame
10.Rear brake light switch stay
11.Rear brake light switch
A. Clamp the AC magneto lead and rectifier/
regulator lead. Insert the clamp into the
cable guide so that the clamp opening
faces to the top of the vehicle.
B. For the position of the end of the fuel tank
breather hose, use the end of the fuel tank
drain hose as a guide.
C. Pass the fuel tank breather hose and fuel
tank drain hose through the cable guide.
The white paint mark on the fuel tank drain
hose should be under the cable guide.
D. Route the AC magneto lead and rectifier/
regulator lead further to the front of the
vehicle than the cable guide.
E. Route the fuel tank breather hose and fuel
tank drain hose through the opening of the
rear brake light switch stay.
F. The clamp position should be inside the
rear frame joint section.
G. Order insignificant-AC magneto lead and
rectifier/regulator lead.
H. To the wire harness
I. To the coolant reservoir
J. Order insignificant-fuel tank breather hose
and fuel tank drain hose.
K. Clamp opening faces to the front of the
vehicle.
L. Install the clamp, facing the head of the
clamp to outside of the vehicle and the end
of the clamp to the front of the vehicle.
M. Inside of the vehicle
N. Front of the vehicle
2-50
CABLE ROUTING