Yamaha FZ8NA Service Manual page 95

1. Clutch cable
2. Left handlebar switch lead
3. Main switch lead
4. Immobilizer lead
5. Horn lead
6. Horn bracket
7. Front wheel sensor lead
8. Throttle cable (return side)
9. Throttle cable (pull side)
10.Brake hose
11.Right handlebar switch lead
12.Throttle cables
A. Route the main switch lead and immobi-
lizer lead through the cable holder.
B. Route the horn lead further inward of the
vehicle than the center of the front fork.
C. The horn lead and lower bracket must not
interfere with each other.
D. Clamp the horn lead to the horn bracket
and face the head of the clamp to outside
of the vehicle and the end of the clamp to
the rear of the vehicle. Cut off the excess
end of the clamp, leaving 2–4 mm (0.08–
0.16 in).
E. Insert the bullet terminal of the horn lead in
the direction shown in the illustration.
F. The horn lead should not protrude out.
G. Route the brake hose further to the right of
the vehicle than this wire and route the
throttle cable and right handlebar switch
lead further to the left. Route the right han-
dlebar switch lead behind the throttle cable
on the rear of the vehicle.
2-46
CABLE ROUTING