1. Clutch cable
2. Left handlebar switch lead
3. Main switch lead
4. Immobilizer lead
5. Horn lead
6. Lower headlight stay
7. Front wheel sensor lead
8. Throttle cable (return side)
9. Throttle cable (pull side)
10.Brake hose
11.Wire harness
12.Right handlebar switch lead
13.Throttle cables
A. Clamp the main switch lead, immobilizer
lead, and left handlebar switch lead at
each of the branches and insert the clamp
into the upper headlight stay. Face the end
of the clamp to the rear of the vehicle.
B. Route the horn lead further inward of the
vehicle than the center of the front fork.
The headlight side cover and front fork
must not be pinched.
C. The horn lead and lower headlight stay
must not interfere with each other.
D. Clamp the horn lead to the Lower headlight
stay and face the head of the clamp to out-
side of the vehicle and the end of the
clamp to the rear of the vehicle. Cut off the
excess end of the clamp, leaving 2–4 mm
(0.08–0.16 in).
E. Insert the bullet terminal of the horn lead in
the direction shown in the illustration.
F. The horn lead should not protrude out.
G. Clamp the wire harness at the branch and
insert it into the upper headlight stay. Face
the end of the clamp to the rear of the vehi-
cle.
H. Connect the meter coupler to the meter.
I. To the headlight lead coupler
2-44
CABLE ROUTING
Need help?
Do you have a question about the FZ8NA and is the answer not in the manual?