Yamaha FZ8NA Service Manual page 109

1. Air filter case drain hose
2. Pickup coil lead
3. Right radiator fan motor lead
4. Immobilizer anti-theft alarm coupler
5. Rear wheel sensor lead coupler
6. Engine ground lead
7. Neutral switch lead
8. Rear brake light switch lead
9. Rectifier/regulator lead
10.Fuel tank breather hose
11.Fuel tank drain hose
12.Main fuse
13.Fuse box 2
14.Waterproof coupler
15.Ground lead
16.ABS ECU (electronic control unit) lead
17.AC magneto lead
18.Battery negative lead
19.Sidestand switch lead coupler
20.Starter motor lead
21.Oil level switch lead coupler
22.O sensor lead coupler
2
23.Left radiator fan motor lead
24.Coolant reservoir drain hose
25.Fuel injection system sub-wire harness
26.Ignition coil sub-wire harness
27.Frame
28.Wire harness
29.Rear wheel sensor lead
30.Immobilizer anti-theft alarm lead
31.Brake hose stay
32.Clutch cable
33.Sidestand switch lead
34.Ignition coil sub-wire harness
35.Oil level switch lead
36.Coolant reservoir hose
A. Route the pickup coil lead under the starter
motor lead.
B. To the starter motor
C. To the engine
D. Route the coolant reservoir hose inside of
the fast idle plunger outlet hose.
E. To the fuel pump
F. Bring the engine ground lead down and the
battery negative lead up. Install each lead
so that the lead convex comes to the top of
the vehicle.
G. Route the wire harness under the clutch
cable.
H. Insert the wire harness wrapping clamp to
the hole of the frame.
I. To the rear brake light switch
J. Atmospheric opening
K. Insert the main fuse to the battery band.
Soapy water can be spread.
L. Route the battery positive lead from inside
of the vehicle to under the wire harness. (It
should not be routed above the wire har-
ness.)
M. Route the main fuse lead so that the
branch of the lead comes to the top of the
vehicle.
N. To the fuel tank
O. Clamp each lead. Route the wire harness
and rear brake light switch lead as shown
in the illustration. For any other lead, order
insignificant. Face the end of the clamp
band to the bottom of the vehicle.
P. Order insignificant-oil level switch lead and
AC magneto lead.
Q. Route the wire harness, AC magneto lead
and oil level switch lead as shown in the
illustration. For any other leads, order insig-
nificant. Face the head of the clamp to the
top of the vehicle and insert the end of the
clamp under the clutch cable, facing it to
the bottom-outside of the vehicle.
2-60
CABLE ROUTING