Siemens MICROMASTER 440 Series Operating Instructions Manual page 43

3 Commissioning
Note - Busy Message
In some cases - when changing parameter values - the display on the BOP shows
. This means the inverter is busy with tasks of higher priority.
Changing single digits in Parameter values
For changing the parameter value rapidly, the single digits of the display can be
changed by performing the following actions:
Ensure you are in the parameter value changing level (see "Changing parameters
with BOP").
1. Press
2. Change the value of this digit by pressing
3. Press
4. Perform steps 2 to 4 until the required value is displayed.
5. Press the
Note
The function button may also be used to acknowledge a fault condition
Motor data for parameterization
P0308 P0310
Cos
P0309
Figure 3-7
42
(function button), which causes the right hand digit to blink.
(function button) again causes the next digit to blink.
to leave the parameter value changing level.
P0304
3_Mot
IEC 56
IM B3
50 Hz 230/400V
0.61 0.35 A
0.12kW
0.81
j
2800 / min
65%
P0305 P0311 P0307
Typical Motor Rating Plate Example
http://nicontrols.com
International English
/ .
12.022
Nr. ED510 3053
I.CI.F
IP54 Rot KL 16
60 Hz 440V Y
0.34A
0.14 kW
Cos 0.81
j
3310 /min
S.F. -- 1.15
MICROMASTER 440 Operating instructions
6SE6400-5CA00-0BP0