Figure 3-6 Changing Parameters Via The Bop - Siemens MICROMASTER 440 Series Operating Instructions Manual

International English
Changing parameters with the BOP
The following descriptions show how to change the parameters; use this
description as a guide for setting any parameters using the 'BOP'.
Changing P0004 – parameter filter function
1
Press
2 Press
3
Press
4 Press
5
Press
6 Only the motor parameters are visible to the user.
Changing P1082 an indexed parameter – setting maximum motor frequency
1
Press
2 Press
3
Press
4
Press
5
Press
6
Press
7 Press
Press
8
drive display (as defined by the customer)
Figure 3-6
MICROMASTER 440 Operating instructions
6SE6400-5CA00-0BP0
Step
to access parameters
until P0004 is displayed
to access the parameter value level
or to the required value
to confirm and store the value
Step
to access parameters
until P1082 is displayed
to access the parameter value level
to display current set value
or to the required value
to confirm and store the value
until r0000 is displayed
to return the display to the standard
Changing parameters via the BOP
http://nicontrols.com
3 Commissioning
Result on display
Result on display
41