Advertisement
Installation
§ Connect the cable of the weighing platform to the indicator.
Note:
The cable gland along with the screw fasteners is already pre-assembled. Use extreme
care when attaching or detaching a cable.
§ Strip off the insulation at the cable end and attach the cable as follows:
– Route the cable through the cable gland.
– Properly tighten the screw fasteners of the cable gland
– Remove the casing from a section of the cable end (see illustration). The shield (1)
must have contact with the clamps (2).
– Expose approximately 15 cm (6 inches) of the wires (3) for installation.
§ Attach the cable to the weighing platform as follows:
– Expose approximately 5 cm (2 inches) of the wires for installation.
– Expose approximately 1 cm (1/2 inch) of the wires and attach ferrules to the wires.
– Securely attach the wires to the screw terminals (blue = plus, brown or black =
Wiring Diagram for the Indicator
No. Signal name
1
BR_POS
2
SENSE_POS
3
OUT_POS
4
OUT_NEG
5
SENSE_NEG
6
BR_NEG
Color Codes of the Wiring for Weighing Platforms, Models CAPP..-LU
Platform size
Wiring Diagram for the Indicator
in inch
Nr.: 1
12,6 x 9,5
Blue
15,8 x 11,8
Blue
19,7 x 15.8
Blue
24 x 18
Blue
24 x 24
Blue
30 x 24
Blue
30 x 30
Blue
36 x 36
Blue
48 x 48
Blue
60 x 48
Blue
60 x 60
Blue
Meaning
Bridge supply voltage, positive
Sense (+) Bridge supply voltage
Measuring voltage, positive
Measuring voltage, negative
Sense (–) Bridge supply voltage
Bridge supply voltage, negative
2
3
4
5
Green
White
Red Gray
Green
White
Red Gray
Green
White
Red Gray
Green
White
Red Gray
Green
White
Red Gray
Green
White
Red Gray
Green
White
Red Gray
Green
White
Red Gray
Green
White
Red Gray
Green
White
Red Gray
Green
White
Red Gray
minus).
6
Black
Black
Black
Black
Black
Black
Black
Black or Brown
Black or Brown
Black or Brown
Black or Brown
5
Advertisement
