Installing A Qsfp+ Optical Transceiver - IBM G8052 Installation Manual

CAUTION:
This product might contain one or more of the following devices: CD-ROM
drive, DVD-ROM drive, DVD-RAM drive, or laser module, which are Class 1
laser products. Note the following information:
v Do not remove the covers. Removing the covers of the laser product could
v Use of the controls or adjustments or performance of procedures other
(C026)
CAUTION:
Data processing environments can contain equipment transmitting on system
links with laser modules that operate at greater than Class 1 power levels. For
this reason, never look into the end of an optical fiber cable or open
receptacle. (C027)
To install an SFP+ optical transceiver in an SFP+ port, complete the following steps.
Note: To avoid damage to the cable or the SFP transceiver, do not connect the
1. Remove the safety cap and pull the locking lever into the down (unlocked)
2. Insert the transceiver into the port until it clicks into place. Use minimal pressure
3. Pull up the locking lever to lock the transceiver into place.
4. Connect the fiber-optic cable.

Installing a QSFP+ optical transceiver

The QSFP+ ports accept supported QSFP+ transceivers. The QSFP+ optical
transceiver provides an MTP cable connector for connecting to external ports.
32
IBM System Networking RackSwitch G8052: Installation Guide
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
than those specified herein might result in hazardous radiation exposure.
cable before you install the transceiver.
position.
when you insert the transceiver into the slot. Do not use excessive force when
you insert the transceiver; you can damage the transceiver or the SFP+ slot.
The transceiver has a mechanical guide key to prevent you from inserting the
transceiver incorrectly.
To remove a SFP+ optical transceiver, disconnect the fiber-optic cable, and pull
down the locking lever to release the transceiver. After you remove the
transceiver, replace the safety cap.