Removing The Rackswitch Chassis From An Idataplex Rack - IBM G8052 Installation Manual

6. Loosen and remove the M4 screws that attach the front mounting brackets to

Removing the RackSwitch chassis from an iDataPlex rack

To remove the RackSwitch from the iDataPlex rack, complete the following steps:
1. Disconnect all cables.
2. Loosen and remove the M6 washers, screws, and clip nuts that attach the
3. Loosen and remove the M6 washers and screws that mount the switch unit into
38
IBM System Networking RackSwitch G8052: Installation Guide
each side of the switch.
9
alignment plate.
4
2
3
the rack.
1
7
8
10
9