IBM G8052 Installation Manual page 32

DANGER
(L002)
To install the RackSwitch in a standard equipment rack, complete the following
steps:
1. Locate and record the product switch information to configure and register your
2. Use the M4 screws to attach a mounting bracket to each side of the switch.
3. Slide the switch into the rack.
4. Use M6 screws, washers, and clip nuts (or cage nuts) to secure the switch unit
18
IBM System Networking RackSwitch G8052: Installation Guide
Rack-mounted devices are not to be used as shelves or work spaces.
product and set aside. See "Before installing the RackSwitch" on page 13.
Note: If this switch is a replacement switch, copy the product information from
the original switch onto the RID label that is shipped with replacement
switch and affix the new label to the bottom of the new switch.
Torque the screws to approximately 2.0 newton-meters (Nm) +/- 0.1 Nm (17.7
inch-pounds).
to the rack. Torque the screws to approximately 5.7 Nm +/- 0.1 Nm (50
inch-pounds).
6
5