Switch Ports - IBM G8052 Installation Manual

DANGER
Each power supply can be connected to a separate AC circuit to mitigate the risk of
down time during a power failure. When used in a redundant configuration, the dual
power supplies have a load-sharing capability that enables each power supply to
operate at approximately 50% of full load. Using redundant power can minimize the
power disruption during a power supply failure and extend the expected lifetime of
each power supply by operating normally in a conservative power mode.
There is no power switch on the G8052; the switch unit powers up when power is
supplied through the power cords.
The Power Supply LED indicates the status of the power supplies. The LED flashes
when only one power cord is connected, and is steady when both power cords are
connected.

Switch ports

The RackSwitch G8052 switch ports and port options are described in the following
sections.
10/100/1000BASET ports
CAUTION:
This product might contain one or more of the following devices: CD-ROM
drive, DVD-ROM drive, DVD-RAM drive, or laser module, which are Class 1
laser products. Note the following information:
v Do not remove the covers. Removing the covers of the laser product could
v Use of the controls or adjustments or performance of procedures other
(C026)
CAUTION:
Data processing environments can contain equipment transmitting on system
links with laser modules that operate at greater than Class 1 power levels. For
this reason, never look into the end of an optical fiber cable or open
receptacle. (C027)
6
IBM System Networking RackSwitch G8052: Installation Guide
An electrical outlet that is not correctly wired could place hazardous
voltage on the metal parts of the system or the devices that attach to the
system. It is the responsibility of the customer to ensure that the outlet is
correctly wired and grounded to prevent an electrical shock. (D004)
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
than those specified herein might result in hazardous radiation exposure.