Table of Contents
Advertisement
Installation
Between
Base &
Wall Cabinets
NOTE: 1/4" thick side panels can be inserted
into the case trim, making the rough-in the same
as the outside trim width, 36".
Installation
At End-of-Run
NOTE: 1/2" thick side panels shown. Side panels
can be any thickness. Add side panel thickness to
outside trim width (36") to calculate the rough-in
dimension. The leading (front) edge must be
finished to match surrounding cabinetry.
Frameless
Cabinets
Side panels are required whenever the sides
of the refrigerator will be exposed.
1/2" to 3/4" side panels are normally set into
place and fastened to adjacent cabinetry or to
the back wall before rolling the refrigerator
into the opening.
Roughed-In Dim.
Finished Dim.
Roughed-In Dim.
Side panels, 1/2" minimum
thickness are required when
using frameless cabinets. The
side panel acts as a spacer
between the cabinet and the case
trim and prevents interference
with cabinet door swing. The
leading (front) edge must be
finished to match surrounding
cabinetry.
Design Information
Therefore, the rough-in dimensions must
allow for side panel thickness. In both a flush
and semi-flush installation, the finished
dimension, (the width of the opening after
side panels are installed), must accommodate
the full width of the refrigerator.
See page 9 for side panel sizes.
Flush and Semi-Flush
Installations
1/4" Thick
Side Panels
Finished Dim.
35-1/2"
36"
Flush and Semi-Flush
Installations
1/2" Thick
Side Panels
36"
37"
36" Stainless Bottom Mount Refrigerators
Cabinet
1/4" Side Panels. Insert end of
side panel into trim
Cabinet
1/2" To 3/4" Side Panels. Leading
Edge Flush With Cabinet
Refrigerator
Cabinet
1/2" To 3/4" Side Panels. Leading
Edge Flush With Cabinet
Refrigerator
Cabinet
Refrigerator door
Refrigerator
Cabinet
Refrigerator door
Cabinet
Refrigerator door
4
Advertisement
Table of Contents
