Table of Contents
Advertisement
6
Step
Secure
Refrigerator
to Sides
7
Step
Connect
Water
Supply
8
Step
Connect
Power
Note: Whenever possible,
perform this step for additional
anti-tip security. This step can be
used as an alternate to Step 4,
Anti-Tip bracket installation,
whenever brackets cannot be
used.
When using 1/2" to 3/4" side panels, the
front flange of the case trim is attached to the
side panel.
• Open fresh food door to access case trim.
• Drill hole in trim below fresh food opening.
Drive screw through trim and side panel.
• Follow the same procedure on opposite side.
Check to be sure that refrigerator power cord
is not plugged into the wall outlet.
• Locate and bring copper tubing to the front
of the cabinet.
• The copper tubing should be just long
enough to reach the coupling. Excess tubing
length could interfere with drawer closing or
toekick installation.
• Slip a 1/4-1/4 union nut (provided) over
both ends of the copper tubing at the right
front leg of the refrigerator and couple the
lines.
• Turn on the water to check for leaks.
• Connect the refrigerator power cord plug
to properly grounded receptacle, accessible
through the top left side of the hood
opening.
• Check to make sure power to refrigerator is
on by opening refrigerator door to see if
interior lights are on.
Installation
36" Stainless Bottom Mount Refrigerators
Stud
OR
If refrigerator is installed between cabinets
with no side panels or in a custom enclosure,
install a spacer block as shown.
• Open fresh food door to access case trim.
• Drill hole in trim below fresh food opening.
Drive screw through trim and into block.
• Follow the same procedure on opposite side.
Refrigerator
Cabinet
Door
Spacer
Block
11
Advertisement
Table of Contents
