Tightening Torques; Tightening Torques For General Use Screws, Bolts And Nuts - wsm wg972-e4 Workshop Manual

WG972-E4, WSM

3. TIGHTENING TORQUES

Screws, bolts and nuts must be tightened to the specified torque using a torque wrench, several screws, bolts and
nuts such as those used on the cylinder head must be tightened in proper sequence and the proper torque.
[1] TIGHTENING TORQUES FOR GENERAL USE SCREWS, BOLTS
AND NUTS
If the tightening torque is not specified, refer to the table below for the none specified torques values.
Indication on
top of bolt
Indication on
top of nut
Unit N·m
M6 7.9 to 9.3
M8 18 to 20
M10 40 to 45
M12 63 to 72
No-grade or 4T
kgf·m lbf·ft
0.80 to 0.95 5.8 to 6.8
1.8 to 2.1 13 to 15
4.0 to 4.6 29 to 33
6.4 to 7.4 47 to 53
1-S12
No-grade or 4T
N·m kgf·m
9.81 to 11.2 1.00 to 1.15
24 to 27 2.4 to 2.8
49 to 55 5.0 to 5.7
78 to 90 7.9 to 9.2
ENGINE
9Y1211108ENS0004US0
7T
lbf·ft
7.24 to 8.31
18 to 20
37 to 41
58 to 66
9Y1211108ENS0005US0
KiSC issued 07, 2015 A