wsm wg972-e4 Workshop Manual page 120

WG972-E4, WSM
Valves
1. Remove the valve caps (2).
2. Remove the valve spring collet (3), pushing the valve spring
retainer (4) with valve spring replacer (1).
3. Remove the valve spring retainer (4), valve spring (5) and valve
stem seal (6).
4. Remove the valve (7).
(When reassembling)
• Wash the valve stem and valve guide hole, and apply engine oil
sufficiently.
• After installing the valve spring collets, lightly tap the stem to
assure proper fit with a plastic hammer.
• Install a new stem seal on the valve guide (9) vertically with a jig
(8) when insert the stem seal (6). (See page G-32: "Valve Stem
Seal Replacing Tool".)
IMPORTANT
• Be sure stem seal (6) seats firmly against groove of valve
guide (10).
• Use care to prevent damage to lip of stem seal and valve
stem when remove the valve spring collet by compressing
the valve spring.
• Do not change the combination of valve and valve guide.
(1) Valve Spring Replacer
(2) Valve Cap
(3) Valve Spring Collet
(4) Valve Spring Retainer
(5) Valve Spring
1-S29
ENGINE
(6) Valve Stem Seal
(7) Valve
(8) Jig
(9) Valve Guide
(10) Groove of Valve Guide
9Y1211108ENS0044US0
KiSC issued 07, 2015 A