Thermostat; Timing Gear, Camshaft - wsm wg972-e4 Workshop Manual

WG972-E4, WSM

(4) Thermostat

(5) Timing Gear, Camshaft

Thermostat Assembly
1. Remove the thermostat cover mounting screws (1), and remove
the thermostat cover (2).
2. Remove the thermostat assembly (4).
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or equivalent) only at
the thermostat cover side of the gasket (3).
(1) Thermostat Cover Mounting Screw
(2) Thermostat Cover
Fan Drive Pulley
1. Secure the flywheel with flywheel stopper.
2. Remove the fan drive pulley screw.
3. Draw out the fan drive pulley with a puller.
(When reassembling)
• Install the pulley to the crankshaft, aligning the mark (1) on
them.
• Apply engine oil to the fan drive pulley retaining screws. And
tighten them.
Tightening torque Fan drive pulley screw
(1) Alignment Mark
Gear Case
1. Remove the screw.
2. Remove the gear case (1).
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or equivalent) to both
sides of the gear case gasket.
• Be sure to set three O-rings inside the gear case.
(1) Gear Case
Water Pump Assembly
1. Remove the water pump assembly (2) from the gear case
cover.
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or equivalent) to both
sides of water pump gasket (3).
(1) Water Pump Flange
(2) Water Pump Assembly
1-S31
ENGINE
(3) Thermostat Cover Gasket
(4) Thermostat Assembly
9Y1211108ENS0046US0
98 to 107 N·m
10 to 11 kgf·m
72.4 to 79.5 lbf·ft
9Y1211108ENS0047US0
9Y1211108ENS0048US0
(3) Water Pump Gasket
9Y1211108ENS0049US0
KiSC issued 07, 2015 A