Tightening Torques; Tightening Torques For General Use Screws, Bolts And Nuts - wsm V3307-DI-T-E2B Workshop Manual

V3307-DI-T-E2B, WSM

3. TIGHTENING TORQUES

Screws, bolts and nuts must be tightened to the specified torque using a torque wrench, several screws, bolts and
nuts such as those used on the cylinder head must be tightened in proper sequence and the proper torque.
[1] TIGHTENING TORQUES FOR GENERAL USE SCREWS, BOLTS AND
NUTS
When the tightening torques are not specified, tighten the screws, bolts and nuts according to the table below.
Grade
Nominal Unit
Diameter
M6 7.9 to 9.3
M8 18 to 20
M10 40 to 45
M12 63 to 72
Screw and bolt material grades are shown by numbers punched on the screw and bolt heads. Prior to
tightening, be sure to check out the numbers as shown below.
Punched number
None or 4
7 Special screw and bolt S43C, S48C (Refined)
Standard Screw and Bolt
N·m kgf·m
0.80 to 0.95
1.8 to 2.1
4.0 to 4.6
6.4 to 7.4
Screw and bolt material grade
Standard screw and bolt SS41, S20C
Special Screw and Bolt
lbf·ft N·m
5.8 to 6.8 9.81 to 11.2
13 to 15 24 to 27
29 to 33 49 to 55
47 to 53 78 to 90
S-12
ENGINE
kgf·m lbf·ft
1.00 to 1.15 7.24 to 8.31
2.4 to 2.8 18 to 20
5.0 to 5.7 37 to 41
7.9 to 9.2 58 to 66
W10371750
W1012705
KiSC issued 01, 2009 A