wsm wg972-e4 Workshop Manual page 126

WG972-E4, WSM
Bearing Case Cover
1. Remove the bearing case cover mounting screws. First, remove
inside screws (1) and then outside screws (2).
2. Remove the bearing case cover (6).
(When reassembling)
• Fit the bearing case gasket (3) and the bearing case cover
gasket (4) with correct directions.
• Install the bearing case cover (6) to position the casting mark
"UP" (a) on it upward.
• Apply engine oil to the oil seal (5) lip and be careful that it is not
rolled when installing.
• Tighten the bearing case cover mounting screws with even
force on the diagonal line.
Bearing case cover
Tightening torque
mounting screw
(1) Bearing Case Cover Mounting
Screw (Inside)
(2) Bearing Case Cover Mounting
Screw (Outside)
(3) Bearing Case Gasket
(4) Bearing Case Cover Gasket
1-S35
ENGINE
9.81 to 11.3 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
(5) Oil Seal
(6) Bearing Case Cover
(a) Top Mark "UP"
(b) Upside
9Y1211108ENS0057US0
KiSC issued 07, 2015 A