Check Points Of Initial 50 Hours - wsm wg972-e4 Workshop Manual

WG972-E4, WSM

[2] CHECK POINTS OF INITIAL 50 HOURS

Checking Fuel Tank Setting Condition (Gas Line) (If
Necessary) [WG972-GL, WG972-L, WG972-N]
1. Check that LPG or CNG fuel tank is installed firmly.
2. Be sure that the fill up valve and liquid withdrawal valve of the
LPG or CNG fuel tank can be opened and closed easily.
Checking the Connector of Fuel Pipe and Clamps (Gas Line)
[WG972-GL, WG972-L, WG972-N]
1. Check the all connectors of fuel pipe and clamps between gas
tank and gas mixer for leaks.
Replacing Engine Oil
CAUTION
• Be sure to stop engine before replacing engine oil.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw the drain plug (1).
5. Fill new oil up to upper line on the dipstick (2).
IMPORTANT
• When using an oil of different brands or viscosity from the
previous one, remove all of the old oil.
• Never mix two different types of oil.
• Engine oil should have properties of API classification SL
or higher.
• Use the proper SAE Engine Oil according to ambient
temperature.
Above 25 °C (77 °F)
0 °C to 25 °C (32 °F to 77 °F)
0 °C to -20 °C (32 °F to -4 °F)
Engine oil capacity
Tightening torque Drain plug
(1) Drain Plug
G-13
GENERAL
9Y1211108GEG0018US0
9Y1211108GEG0019US0
SAE30 or SAE10W-30, SAE15W-40
SAE20 or SAE10W-30
SAE10W or SAE10W-30
3.4 L
0.90 U.S.gals
33 to 37 N·m
3.3 to 3.8 kgf·m
24 to 27 lbf·ft
(2) Dipstick
9Y1211108GEG0020US0
KiSC issued 07, 2015 A