wsm wg972-e4 Workshop Manual page 121

WG972-E4, WSM
Oil Pan and Oil Strainer
1. Remove the oil pan mounting screws (2).
2. Remove the oil pan (1) by lightly tapping the rim of the pan with
a wooden hammer.
3. Remove the oil strainer (3).
(When reassembling)
• After cleaning the oil strainer, check to see that the filter mesh
in clean, and install it.
• Visually check the O-ring (4), apply engine oil, and install it.
• Securely fit the O-ring to the oil strainer.
• To avoid uneven tightening, tighten oil pan mounting screws in
diagonal order form the center.
• Using the hole numbered "3" (5), install the oil strainer by
mounting screw.
IMPORTANT
• Scrape off the old adhesive completely. Wipe the sealing
surface clean. Now apply new adhesive 3.0 to 5.0 mm
(0.12 to 0.19 in.) thick all over the contact surface. Apply the
adhesive also on the center of the flange as well as on the
inner wall of each bolt hole.
• Cut the nozzle of the "liquid gasket" (Three Bond 1207D or
equivalent) container at its second notch. Apply "liquid
gasket" about 5.0 mm (0.19 in.) thick.
Within 20 minutes after the application of fluid sealant,
reassemble the components.
30 minutes, and pour oil in the crankcase.
(1) Oil Pan
(2) Oil Pan Mounting Screw
(3) Oil Strainer
1-S30
ENGINE
Wait then for
(4) O-ring
(5) Hole Numbered "3"
9Y1211108ENS0045US0
KiSC issued 07, 2015 A
about