Check Points Of Every 200 Hours - wsm wg972-e4 Workshop Manual

WG972-E4, WSM

[5] CHECK POINTS OF EVERY 200 HOURS

Replacing Engine Oil
CAUTION
• Be sure to stop engine before replacing engine oil.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw the drain plug (1).
5. Fill new oil up to upper line on the dipstick (2).
IMPORTANT
• When using an oil of different brands or viscosity from the
previous one, remove all of the old oil.
• Never mix two different types of oil.
• Engine oil should have properties of API classification SL
or higher.
• Use the proper SAE Engine Oil according to ambient
temperature.
Above 25 °C (77 °F)
0 °C to 25 °C (32 °F to 77 °F)
0 °C to -20 °C (32 °F to -4 °F)
Engine oil capacity
Tightening torque Drain plug
(1) Drain Plug
Replacing Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before replacing oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
cause burns.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Apply a slight coat of oil onto the new cartridge gasket.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4. After the new cartridge has been replaced, the engine oil level
normally decreases a little. Thus, operate the engine for a while
and check for oil leaks through the seal before checking the
engine oil level. Add oil if necessary.
IMPORTANT
• To prevent serious damage to the engine, replacement
element must be highly efficient. Use only a KUBOTA
genuine filter or its equivalent.
NOTE
• Wipe off any oil sticking to the machine completely.
(1) Engine Oil Filter Cartridge
G-18
GENERAL
SAE30 or SAE10W-30, SAE15W-40
SAE20 or SAE10W-30
SAE10W or SAE10W-30
3.4 L
0.90 U.S.gals
33 to 37 N·m
3.3 to 3.8 kgf·m
24 to 27 lbf·ft
(2) Dipstick
9Y1211108GEG0020US0
9Y1211108GEG0021US0
KiSC issued 07, 2015 A