Toyota 2013 Rav4 Owner's Manual page 191

226
4-3. Operating the lights and wipers
■
Temporarily lowering sensor sensitivity
The sensitivity of the sensor can be temporarily lowered.
1
Vehicles without a smart key system: Turn the engine switch to the
"LOCK" position while the following conditions are met.
Vehicles with a smart key system: Turn the engine switch off while the fol-
lowing conditions are met.
• The headlight switch is in
• The headlight switch lever is in high beam position.
2
Vehicles without a smart key system: Turn the engine switch to the "ON"
position.
Vehicles with a smart key system: Turn the engine switch to IGNITION
ON mode.
3
Within 5 seconds after
original position then pushing it to the high beam position quickly 9 times,
then leave the lever in high beam position.
Automatic High Beam (headlights) may turn on even the vehicle is stopped.
■
If the Automatic High Beam indicator turns to yellow...
It may indicate a malfunction in the system. Contact your Toyota dealer.
■
Customization
The Automatic High Beam can be turned off.
(Customizable features: →P. 579)
CAUTION
■
Limitations of the Automatic High Beam
Do not rely on the Automatic High Beam. Always drive safely, taking care to
observe your surroundings and turning high beam on or off manually if nec-
essary.
RAV4_OM_OM42809U_(U)
.
2
, repeat pulling the headlight switch lever to the