Table of Contents
Advertisement
5. Connect all cables.
6. Initialize the switch, see Chapter 4, "Initializing the RackSwitch," on page 45.
Installing the RackSwitch in an IBM iDataPlex rack
This section describes how to install the RackSwitch G8000 in an IBM iDataPlex
rack. The iDataPlex mounting kit allows the switch to be mounted either vertically or
horizontally. For information about mounting the RackSwitch in other rack types,
see the following sections:
v "Installing the RackSwitch in a standard equipment rack" on page 20
v "Installing the RackSwitch in an IBM System x
The iDataPlex rack mount kit must be purchased separately. The following table
lists the parts included in the iDataPlex mounting kit.
Attention:
22
IBM System Networking RackSwitch G8000: Installation Guide
Attention:
If this is a switch replacement, make sure the vital product data
(VPD) is updated to avoid losing the licensed electronic entitlement data of the
RackSwitch. For more information, see "Configuring Vital Product Data after a
switch replacement" on page 43.
Table 16. iDataPlex rack mount kit parts
Item number
1
2
3
4
5
6
7
8
For earthquake stability, mount the switch in a 4-post rack.
®
or Power rack" on page 24
Description
Label
M6 locking washers
M6 screws
M6 clip nuts
M4 screws
Switch front bracket
Switch rear bracket
Rear mounting bracket
Quantity
1
8
8
8
16
2
2
2
Advertisement
Table of Contents
