Table of Contents
Advertisement
DANGER
Rack-mounted devices are not to be used as shelves or work spaces.
(L002)
To install the RackSwitch in an iDataPlex rack, complete the following steps:
1. Locate and record the product switch information to configure and register your
product and set aside. See "Before installing the RackSwitch" on page 15.
Note: If this switch is a replacement switch, copy the product information from
the original switch onto the RID label that is shipped with replacement
switch and affix the new label to the bottom of the new switch.
2. Use the M4 screws to attach front and rear mounting brackets to each side of
the switch unit. Torque the screws to approximately 2.0 newton-meters (Nm) +/-
0.1 Nm (17.7 inch-pounds).
3. Use the M6 washers and screws to mount the switch unit into the rack. Torque
the screws to approximately 5.7 Nm +/- 0.1 Nm (50 inch-pounds).
6
5
Chapter 2. Installing the RackSwitch and options
7
1
23
Advertisement
Table of Contents
