Fan Speed Fixing (Air Conditioner / Dx Type Ventilator); Celsius / Fahrenheit Switching (Air Conditioner) - LG V-NET ACS PREMTA000A Installation And User Manual

INSTALLER'S SETTING OPTIONS
172
Fan speed fixing (air conditioner / DX type ventilator)
It is the function to apply different fan speeds automatically for each thermal control status.
h Variable: When COMP is ON, operate as the set fan speed, and when COMP is OFF, operate
at 'ROW' fan speed.
Fixed: When COMP is ON, operate as the set fan speed, and when COMP is OFF, also oper-
ate at the set fan speed.
● Press and hold 'wireless remote controller signal receiver part' of the remote controller for 3
seconds or longer to enter the installer function.
● At the Code field select fan speed fixed setting code value '11'.
- You can press '▲', '▼' button to change the code value.
● At the Value 1 field, press the '▲', '▼' button to select wind amount fixing setting value, and
then press 'Done' button to complete the fan speed fixing setting.
- If you do not press 'Done' button, your changes will not be applied.
h Fan speed fixed setting value
- 01: variable
- 02: fixed
h If no buttons are pressed for about 60 seconds after the setting, it automatically exits from the
setting mode.

Celsius / Fahrenheit Switching (air conditioner)

This function is used for switching the display between Celsius and Fahrenheit.(Optimized only
for U.S.A)
● Press and hold 'wireless remote controller signal receiver part' of the remote controller for
3seconds or longer to enter the installer function.
● Select remote controller Celsius / Fahrenheit Switching code value '12'.
- You can press '▲', '▼' button to change the code value.
● In value1, use '▲', '▼' button to select Celsius control unit setting value, and press 'Done'
button to complete the Celsius / Fahrenheit Switching setting.
- If you do not press 'Done' button, the setting value will not be applied.
h Celsius control unit setting value
- 000: Celsius
- 001: Fahrenjeit
h If there is no button input for about 60 seconds after the setting, it automatically exits from the
setting mode.
INSTALLER'S SETTING OPTIONS
173