Table of Contents
Advertisement
REMOVING & REFITTING OF THE GLASS FRAME
a)
Remove the contemporary trim & ashpan cover from the firebox.
b)
Remove the pilot heat shield, which is held in place at each end by 1 screw.
c)
Remove the top infill panel by sliding it upward out of the clips.
d)
Obtain the Allen key which is located at the bottom right hand side if the firebox.
e)
Loosen each Allen bolt a small amount at a time to prevent damage to the glass
panel. When all the Allen bolts have been removed, lift away the glass frame and
clean as per the previous page.
f)
Refit the glass panel to the firebox, again tightening each bolt a small amount at a
time to prevent stressing the glass panel. Carefully tighten all the bolts to ensure
good compression on the glass panel seal.
g)
Refit the contemporary trim & ashpan to the firebox.
FOLLOWING USE OF THE ALLEN KEY, ALWAYS REMOVE IT FROM THE FIRE AND
REPLACE IT INTO ITS LOCATION IN THE CLIP AT THE BOTTOM RIGHT HAND SIDE
OF THE FIREBOX.
Top infill panel.
7
4 Allen key
fixing screws
Storage of Allen
key
Advertisement
Table of Contents
