Table of Contents
Advertisement
It is advisable to use genuine Flavel replacement parts available from your
supplier or direct from CFM Europe Ltd. (Contact details on the rear of this
booklet)
Bulb Replacement
Flame Effect Bulbs
a)
Disconnect the appliance from the mains supply.
b)
Remove the glass panel or doors as required
c)
Remove the logset
d)
Remove the emberbed by removing the retaining screws and
brackets as shown below. Ensure brick sides are held in position
during removal of these brackets. See fig. 4 below
Fig. 4
Emberbed / Brick side
retaining brackets
e)
The bulbs are located at the rear of the lower assembly, as shown
above in Fig. 5 Replace as necessary using the correct bulb type
and wattage.
f)
Re-assemble in reverse order.
Spare Parts List
22 inch Logset
1000-6711
26 inch Logset
1000-6711
33 inch Logset
1000-6532
Bulb
B-86900
Fan Assembly
B-67210
Flame effect motor
B-87190
Electronic Control Board
B-86610
Fig. 5
Flame effect bulbs
located at rear of
heater
22 inch Emberbed
1000-5438
26 inch Emberbed
1000-6710
33 inch Emberbed
1000-6526
Element
B-82860
8
Advertisement
Table of Contents
