Connection To The Hot Water Supply; Connection To A Very Hot Water Supply - Miele PW 5082 Operating And Installation Instructions

Installation

Connection to the hot water supply

To keep electricity consumption costs
down this machine can be connected
to a (ring) piped hot water supply.
The maximum water temperature at the
stopcock must not exceed 70°C. It is
not economical to run it from an
individual hot water supply if it is not in
continuous use, as the water in the
supply pipes cools down and more
energy would be required to reheat the
water. For hot water connection the
same conditions apply as for cold water
connection.
The inlet hose with the red stripes (hot
water hose) is connected to the
stopcock.
For operational reasons the machine
must not be connected to hot water
only.
If the machine is not connected to a hot
water supply, the hot water inlet hose
must be disconnected and water
settings for the main wash, pre-wash
and rinses must be reprogrammed.
^ Select the Cold option in the
Settings/Supervisor level menu.
54
The programme durations may be
longer.
^ Disconnect the hot water hose (red
stripes).
^ Plug the inlet connection with the
blanking cap supplied.
Connection to a very hot water
supply
It is possible to connect the machine to
a hot water supply, 70°C to a maximum
of 85°C. A special inlet hose is required
for this option. The machine must also
be reprogrammed by a Miele service
technician.