Electrical Connection - Miele PW 5082 Operating And Installation Instructions

Installation

Electrical connection

This machine is supplied with a
connection cable and a NEMA L15-30P
plug.
,
The voltage, rated load and fuse
rating are given on the data plate.
Please ensure these match the site
mains supply.
Connection to the electricity supply
must only be carried out by a suitably
qualified and competent person, in
strict accordance with current local and
national safety regulations.
Connection should be made via a
suitable connection socket or isolator
which complies with local and national
safety regulations and which is easily
accessible for disconnecting the
machine from the electrical supply. If
the appliance is hard wired, provision
must be made on site to switch off all
poles. Switches with a minimum all-pole
contact gap greater than 3 mm are
suitable for isolating the machine.
These include circuit breakers, fuses
and relays (IEC/EN 60947).
,
If the machine is disconnected
from the electricity supply ensure
adequate measures are taken to
ensure that the machine cannot be
reconnected to the electricity supply
until all work has been carried out.
56
Should the connection cable require
replacing or changes be necessary in
the electrical installation including
checking and/or replacing the fuse
please make sure this is done by an
approved electrician to ensure
compliance with all local and national
electrical safety requirements.
For extra safety and protection we
recommend connecting the machine by
a 30mA residual current device (RCD).
,
This machine must be
connected to a permanent electricity
supply so that the door can always
be opened.
WARNING:
THIS APPLIANCE
MUST BE EARTHED