Configuring Video Parameters - HIKVISION DS-7200HVI-SH series User Manual

User Manual of DS-7200HVI/HFI-SH Series DVR
Please refer to step 7 of Chapter 11.1 Configuring O S D S ettings .
7. Click the A pply button to save the settings.
Note: You can also click the Restore to restore the current OSD settings to the default parameters.

11.3 Configuring Video Parameters

Steps:
1. Enter the Image Settings interface.
Menu > Camera > Image
2. Select the camera to set image parameters.
3. Set the period of a day for configuring independent image parameters so as to satisfy different light
conditions, e.g., daylight and night time. Two periods can be configured. When you have configured Period 1,
the Period 2 is remained as the Other Ti m e .
4. Select the mode from the drop-down menu according to different light conditions.
Four modes are selectable:
Standard: in general lighting conditions (default).
Indoor: the image is relatively smoother.
Dim L ight: the image is smoother than the other three modes.
O utdoor: the image is relatively clearer and sharper. The degree of contrast and saturation is high.
5. Adjust the image parameters including the brightness, contrast, saturation, hue and sharpness by moving the
sliding bar or increasing/decreasing the value.
Note:
The adjustable value range for the brightness, contrast, saturation and hue is 0~ 255 and for the
sharpness is 0~ 15.
6. You can click the Copy button to copy the image settings of the current camera to other cameras. Please
refer to step 7 of Chapter 11.1 Configuring O S D S ettings .
7. On the Image Settings interface, click the A pply button to save the settings.
Note: you can click the Restore button to restore the current image settings to default parameters.
Figure 1 1.5 I mage S ettings I nterface
146