Zone 2 Remote Control (R-S700 Only) - Yamaha R-S500 Owner's Manual

CONTROLS AND FUNCTIONS

Zone 2 remote control (R-S700 only)

This section describes the function of each button on the
Zone 2 remote control, which is used to control Zone 2.
Note
The Zone 2 remote control comes with a battery already installed.
Before using the Zone 2 remote control for the very first time,
pull out the insulation sheet, as shown.
■ Common controls for Zone 2
The following buttons can be used no matter which input
source is selected for Zone 2.
1 Infrared signal transmitter
Sends infrared signals.
2 A (Zone 2 standby)
Sets Zone 2 to standby mode.
3
(Zone 2 on)
Turns on Zone 2.
4 ID
Changes the Zone 2 remote control ID (see page 35).
5 Zone 2 input selector buttons
Selects the desired input source for Zone 2.
10
En
6 MUTE
Mutes the sound output to Zone 2. Press again to restore
the sound output to the previous volume level.
7 VOLUME +/–
Increases or decreases the sound output level of Zone 2.
■ FM/AM controls
The following buttons can be used when TUNER is
selected as the input source for Zone 2.
8 FM, AM
Sets the FM/AM tuner band to FM or AM when TUNER
is selected as the input source (see page 20).
9 PRESET j / i
Selects a preset FM/AM station when TUNER is selected
as the input source (see page 24).
0 TUNING jj / ii
Selects the tuning frequency when TUNER is selected as
the input source (see page 20).
A Numeric buttons, ENTER
Specifies the frequency or the preset number of the FM/
AM station when TUNER is selected as the input source
(see page 21).
■ iPod controls
The following buttons can be used when DOCK is
selected as the input source for Zone 2, for listening to an
iPhone/iPod. For more information, see page 26.
B INFO
Insulation sheet
C MENU/ Ee / b / a / ENTER
D
/